Ugly Motors

KOŁA

Oś koła Softail z końcówką kęsową 3/4″. Tył. 30 cm

100,32 € z VAT

3/4" (19.05cm) diameter x 30cm long. Designed for Softail style swingarms. Comes complete with billet tip end and Allen head (socket head cap) bolt for both sides of the axle. The billet tips are special machined for Softail axle adjuster bolts. Lengths mentioned are outside swing to outside swing.

KOŁA

CHROM PIASTA Z PODWÓJNYM KOŁNIERZEM, OTWORY 7/16 I 3/8

231,65 € z VAT

KOŁA

PIASTA Z POJEDYNCZYM KOŁNIERZEM, CHROM, 40 SZPRYCH

230,78 € z VAT

Front; 5/16 holes; 3/4 axle

KOŁA

WCZESNA OŚ PRZEDNIA

46,44 € z VAT

OEM reproduction. OEM replacement reference 43872-36.

KOŁA

PIASTA KOŁA PRZEDNIEGO, CHROM

256,21 € z VAT

KOŁA

Oś koła 3/4″ z końcówką kęsową Softail. Tył. 38 cm

102,75 € z VAT

3/4" (19.05cm) diameter x 38cm long. Designed for Softail style swingarms. Comes complete with billet tip end and Allen head (socket head cap) bolt for both sides of the axle. The billet tips are special machined for Softail axle adjuster bolts. Lengths mentioned are outside swing to outside swing.

KOŁA

ZESTAW OSPRZĘTU OSI PRZEDNIEJ

16,75 € z VAT

KOŁA

Łożysko ABS do koła 21″

18,51 € z VAT

- ABS bearing for use with a custom (non-stock) wheel diameter - This special bearing prevents the ECU triggering trouble codes - 25mm ID x 52mm OD x 15mm deep - Front / rear use - Used on ABS sensor side only - On the opposite side of the wheel the 513727 regular non-ABS wheel bearing is used - Tech tip. Why this bearing? On ABS equipped bikes; the ECU (on-board computer) knows what specific wheel diameter is factory installed on that bike. When installing another wheel diameter; that is custom for the specific bike; the ECU will trigger fault codes / trouble codes. Special ''ABS bearings for custom diameter wheels'' will prevent these ''different wheel diameter'' trouble/fault codes.

KOŁA

Łożysko ABS dla koła 26″

18,51 € z VAT

- ABS bearing for use with a custom (non-stock) wheel diameter - This special bearing prevents the ECU triggering trouble codes - 25mm ID x 52mm OD x 15mm deep - Front / rear use - Used on ABS sensor side only - On the opposite side of the wheel the 513727 regular non-ABS wheel bearing is used- Tech tip. Why this bearing? On ABS equipped bikes; the ECU (on-board computer) knows what specific wheel diameter is factory installed on that bike. When installing another wheel diameter; that is custom for the specific bike; the ECU will trigger fault codes / trouble codes. Special ''ABS bearings for custom diameter wheels'' will prevent these ''different wheel diameter'' trouble/fault codes.

KOŁA

PODKŁADKA DYSTANSOWA ŁOŻYSKA KOŁA .032 CALA

9,70 € z VAT

KOŁA

PODKŁADKA DYSTANSOWA ŁOŻYSKA KOŁA .016 CALA

10,79 € z VAT

KOŁA

PODKŁADKA DYSTANSOWA ŁOŻYSKA KOŁA .008 CALA

10,49 € z VAT

KOŁA

PODKŁADKA DYSTANSOWA ŁOŻYSKA KOŁA .004 CALA

10,79 € z VAT

Brak w magazynie

KOŁA

Przednie koło 2.15 x 21, 40 szprych

577,40 € z VAT

Steel hub with metal center valve. Chrome plated 40-spoke replacement spoke wheel; laced and trued. Seals are installed; bearing spacing is pre-set and wheel is ready for installation. Wider than stock wheels are for wide tire applications. An OEM fitment may not be applicable due to OEM width restrictions in fender; belt; etc. Note: For all wire wheels it is advised to check spoke tension before installing the tire. After approx. 250km the spoke tension must be checked again to insure a correct spoke tension. After each 5000km; or as part of regular maintenance; a spoke-check is advised to insure spoke tension is still correct.

KOŁA

Boczny zawór paska obręczy, 16″

12,79 € z VAT

Used on inside of rim to protect inner tube from protruding spokes.

KOŁA

Zawór środkowy paska obręczy, 18″

13,59 € z VAT

Used on inside of rim to protect inner tube from protruding spokes

KOŁA

Zawór środkowy paska obręczy, 19″

13,28 € z VAT

Used on inside of rim to protect inner tube from protruding spokes

KOŁA

Oś koła 3/4″ z końcówką kęsową Softail. Tył. 29 cm

100,32 € z VAT

3/4" (19.05cm) diameter x 29cm long. Designed for Softail style swingarms. Comes complete with billet tip end and Allen head (socket head cap) bolt for both sides of the axle. The billet tips are special machined for Softail axle adjuster bolts. Lengths mentioned are outside swing to outside swing.

Brak w magazynie

KOŁA

Oś koła 3/4″ z końcówką kęsową Softail. Tył. 31 cm

100,32 € z VAT

3/4" (19.05cm) diameter x 31cm long. Designed for Softail style swingarms. Comes complete with billet tip end and Allen head (socket head cap) bolt for both sides of the axle. The billet tips are special machined for Softail axle adjuster bolts. Lengths mentioned are outside swing to outside swing.

KOŁA

Oś koła 3/4″ z końcówką kęsową Softail. Tył. 34,5 cm

102,75 € z VAT

3/4" (19.05cm) diameter x 34.5cm long. Designed for Softail style swingarms. Comes complete with billet tip end and Allen head (socket head cap) bolt for both sides of the axle. The billet tips are special machined for Softail axle adjuster bolts. Lengths mentioned are outside swing to outside swing.

KOŁA

Oś koła Softail z końcówką 3/4″. Tył. 33 cm

100,32 € z VAT

3/4" (19.05cm) diameter x 33cm long. Designed for Softail style swingarms. Comes complete with billet tip end and Allen head (socket head cap) bolt for both sides of the axle. The billet tips are special machined for Softail axle adjuster bolts. Lengths mentioned are outside swing to outside swing.

KOŁA

Oś koła z końcówką kęsową 3/4″ Softail. Tył. 39 cm

102,75 € z VAT

3/4" (19.05cm) diameter x 39cm long. Designed for Softail style swingarms. Comes complete with billet tip end and Allen head (socket head cap) bolt for both sides of the axle. The billet tips are special machined for Softail axle adjuster bolts. Lengths mentioned are outside swing to outside swing.