SWITCH RH 4 REV/2 THROTTL

Required for installation of Revolver Throttle Kit on bikes with ignition and starter switches in stock throttle assembly

Fits 7/8″ bars (22.2 mm)

Extra-narrow design is only 26 mm wide

Push In/Out engine switch

Momentary 2-pole starter switch

Starter switch has two separate circuits, one normally open, one normally closed for street bikes that use a headlight/starter cutoff

550 mm long wiring harness with brake light switch circuit wiring

Brake light circuit wiring pigtail 120 mm long with female spade connectors

Stainless steel screws and internal rubber pad positions switch on handlebar securely without drilling holes

Wiring harness has bare, tinned wires without connector for easy installation of OE connector body

Made in Italy by Domino